Lauda PROLINE Edition X P 12 C, Руководство по эксплуатации

Страница: 94 / 116

Proline Edition X heating thermostats
94
Interface modules
YACE0099
/
10/9/2018
Command Explanation
IN_PAR_06 Read control parameter TvE (0 = OFF)
IN_PAR_07 Read control parameter TdE
IN_PAR_09 Read value of correction limitation
IN_PAR_10 Read control parameter XpF
IN_PAR_14 Read setpoint offset
IN_PAR_15 Read control parameter PropE
IN_DI_01 State of contact input 1: 0 = open/ 1 = closed
IN_DI_02 State of contact input 2: 0 = open/ 1 = closed
IN_DI_03 State of contact input 3: 0 = open/ 1 = closed
IN_DO_01 State of Contact output 1:
0 = make-contact open/ 1 = make-contact closed
IN_DO_02 State of Contact output 2:
0 = make-contact open/ 1 = make-contact closed
IN_DO_03 State of Contact output 3:
0 = make-contact open/ 1 = make-contact closed
IN_MODE_00 Keyboard Master: 0 = free / 1 = locked
IN_MODE_01 Control: 0 = int. / 1 = ext. Pt100 / 2 = ext. Analogue / 3 = ext. Serial
IN_MODE_02 Standby operation: 0 = Device ON / 1 = Device OFF
IN_MODE_03 Keyboard Command Remote Control: 0 = free / 1 = locked
IN_MODE_04 Setpoint offset source: 0 = normal/ 1 = ext. Pt/ 2 = ext. analogue/ 3 =
ext. serial
TYPE Read device type (response e.g. "P 8")
VERSION_R Read software type of control system
VERSION_S Read software type of protection system
VERSION_B Read software type of Command
VERSION_T Read software type of cooling system
VERSION_A Read software type of analogue module
VERSION_V Read software type of RS-232/485 module
VERSION_D Read software type of digital module
VERSION_M_0 Read software type of solenoid valve (cooling water)
VERSION_M_1 Read software type of solenoid valve (automatic refilling)
VERSION_M_3 Read software type of solenoid valve (shut-off valve 1)
VERSION_M_4 Read software type of solenoid valve (shut-off valve 2)
VERSION_M_5 Read software type of high temperature cooler
STATUS Read equipment status 0 = OK, -1 = error
STAT Read error diagnosis response:
XXXXXXX

X = 0 no error, X = 1 error
1. char = fault
2. char = alarm
3. char = warning
4. char = over temperature
5. char = low bath level
6. char = high bath level (at adjustment alarm)
7. char = no external control variable
RMP_IN_00_XXX Read a programme segment XXX
(response: e. g. 030.00_010.00_005.00_001.00 > set point tempera-
ture 30.00 °C, time = 10 min, tolerance = 5.00 K, pump level = 1)
RMP_IN_01 Read the current segment number
RMP_IN_02 Read the set number of programme runs