Lauda PROLINE Edition X P 12 C, Руководство по эксплуатации

Страница: 38 / 116

Proline Edition X heating thermostats
38
Starting up
YACE0099 / 10/9/2018
7.7 Important settings
7.7.1 Temperature setpoint setting
The setpoint is the temperature which the thermostat should reach and maintain constant.
Master (main level)
SEt

Press key until
SEt
(Setpoint) appears.

Press, display flashes.
or

Enter the setpoint with the two keys (

Section 7.4.1 General key
functions and pilot lamps).
Wait 4 seconds or

Display flashes 4 s

new value is automatically accepted, or
value is accepted immediately with Enter key.
 
For safety reasons the setpoint can only be set up to 2 °C above
upper limit of the operating temperature range for the relevant de-
vice type.

In the following cases the manual setpoint entry is blocked:
Setpoint is taken from the analog module, from the programmer in
the Command remote control or via the serial interface.
Command
T
set
or T
fix

or the soft key T
set
opens the
setpoint window.

123.45 is the setpoint which is still active.
The upper and lower limit temperatures
are displayed (device-specific values).
There are three different possible entry
methods:
1. Change the value with the or
keys. First you vary the 1/10 °C values. If
you hold the key pressed longer, then full
degrees change.
2. Enter the complete number with the nu-
merical duo keys and the key for the
negative sign and decimal point.
3. Using or , move the flashing cursor
line to the decimal place which you would
like to change and then change it with
or .
Help Menu Screen T
set
T
fix
6 7 8 9 0
1 2 3 4 5
Enter new setpoint:
123,
45
Min: -40,00°C Max:202,00°C