PLMNL0286 REV. B, Effective Date: 06/06/19
40
FiberMINI
®
with Auto Focus (AF) Operation Manual
3. Verify the fiber and fiber input are
thoroughly clean.
4. Remove the fiber optic cable from the
cutting head according to the fiber
manufacturer’s instructions and
The open area of the fiber
receiver MUST be covered.
o
Use the manufacturer
supplied dust cap.
OR
o
Use blue painter’s tape or
equivalent.
Cover the fiber end with the
appropriate cap from the fiber
manufacturer.
Give special attention to the
fiber optic cable.
Take care to insure dirt and
debris do not contaminate
the glass block at the end of
the fiber.
Plug or tape off the fiber
input to prevent
contamination.
Damage will occur if:
The output is not
covered with
manufacturer’s cap.
The fiber input adapter
is not protected by the
provided dust cover.
5. Take the head to a clean area.
For steps 6 to 8, see
6. Remove the (4) M4 SHCS securing
the collimator assembly to the body.
7. Remove the collimator assembly.
8. Verify the engagement o-ring
(PLMOR0032) is present and
undamaged in the top of the body.
Replace as necessary.
Figure 51
Содержание FiberMINI 2.0
Страница 1: ...FiberMINI 2 0 With Auto Focus AF Operation Manual ...
Страница 23: ...PLMNL0286 REV B Effective Date 06 06 19 18 FiberMINI with Auto Focus AF Operation Manual Figure 17 ...
Страница 52: ...PLMNL0286 REV B Effective Date 06 06 19 47 FiberMINI with Auto Focus AF Operation Manual Figure 55 ...