LaserMech FiberMINI 2.0, Руководство по эксплуатации

Страница: 12 / 54

PLMNL0286 REV. B, Effective Date: 06/06/19
7
FiberMINI
®
with Auto Focus (AF) Operation Manual
8. Rotate the brightness knob and adjust
the camera to full brightness (see
Figure 7 ).

If it is too bright, rotate the
brightness knob slightly, to suit.
9. Rotate the camera focus knob
(see Figure 7 ) until the end of the gas
jet tip is in focus with a clear image.
See
Figure 8 .

You should be able to see tooling
marks on the end of the tip.
Figure 8
10. Move the focus lens to the center of
travel. See Section 4 for more details.
Do not look directly into the red
beam.
If the beam is not centered in the tip
orifice, proceed to step 11.
11. Use a 1/8 inch hex wrench to loosen
or tighten the (2) adjusting screws so
the beam is centered in the tip orifice.
See
Figure 9 .
Figure 9

The image on the screen should
be similar to
Figure 10 .
Figure 10
Beam is centered
It is sometimes helpful to rotate the
camera while it is seated against the tip
retainer assembly to confirm the beam
centering.