LaserLine Flatwork Ironer Series, Инструкция по эксплуатации

Страница: 29 / 238

GL16 Installation
2-11
Required Tools
pipe joint compound
Gas Connection
The nameplate, located on the back of the right
end frame, specifies the gas requirements of your
particular unit (Figure 2-11). The unit requires gas
supplied at the correct pressure. If the gas pressure
supplied to the unit is either too high or too low,
the unit will work improperly or not at all. Confirm
the pressure of the gas supply meets the
requirements shown on the unit’s nameplate.
CAUTION
The gas supply must match
the specific gas
requirements shown
on the nameplate.
If a high pressure gas supply is used, an
additional regulator is required. For natural or
manufactured gas only, a high pressure gas supply
measures more than 11" (280 mm) of pressure
using a water column manometer connected
upstream of the supplied pressure regulator. For
more information on checking the pressure of the
gas supply within this chapter, proceed to the
Pre-
Operational Checkout section, Gas
Connection Checkout procedure, Gas Supply .
All labor and materials required for the gas
connection to the unit except those items shipped
with the unit are a local responsibility. Local codes
and regulations must be followed for proper
installation.
WARNING
Only qualified personnel
should install and adjust any
gas components. Improper
installation could result in
serious injury.
The gas connection to the unit is made at the
rear of the left end frame. A 1" gas inlet
connection is provided to connect the incoming
gas line (Figure 2-17). The required gas inlet piping
is shown in Figure 2-18. The gas pressure
regulator and manual gas shut-off valve are
supplied with the unit. Other components must
be locally supplied.
NOTE: Pipe joint compound is
required on all gas line
connections to assure a leakproof
installation. Comply with local
codes.
Figure 2-17: The location of the 1" gas supply
connection is at the rear of the left
end frame.