LaserLine Flatwork Ironer Series, Инструкция по эксплуатации

Страница: 237 / 238

3010900
D R A D N A T S G N I T A R E P O
R E N O R I R E N R U B 1
: l e d o M : # l a i r e S : e t a D
/ /
: y b d e v o r p p A
T N E T N O C C I R B A F / K R O W T A L F E R U T A R E P M E T G N I T T E S D E E P S G N I T A R E P O
/
/
/
/
/
/
/
/
/
Warm Rinse
A warm rinse allows more water to be extracted from the material. This means the ironer needs to
remove less moisture from the flatwork to produce a dry, high quality finish. Furthermore, the ironer can be
run faster if the final rinse is warm.
Moisture Retention (MR)
After extraction, the optimum MR is 30% - 35% for mixed-fiber-content fabrics and 45% - 50% for cotton
fabrics. To determine the MR after extraction, use a precise scale to measure the “still wet, but extracted”
flatwork; then weigh again after the same flatwork is “completely dry”. Subtract the weight of the “still wet, but
extracted” flatwork from the “completely dry” flatwork. Divide the weight difference by the “completely dry”
flatwork weight. Finally, multiply the resulting weight by 100 to determine the MR percentage.
The optimum MR after ironing is 4% or less. Ironing is not intended to remove 100% of the moisture
from the flatwork. Therefore, feel the flatwork when it first comes out of the unit; there should be a slight
moisture content. Allow the flatwork to sit for a few minuts to allow excess steam and heat to dissipate in the
air. Check the flatwork again; it should now feel dry to the touch. For more information, review the
Instruction
Manual, Flatwork Handling procedure.
NOTE: This Operating Standard form needs to be completed and approved by the laundry manager at each facility. Each laundry facility uses different means to
accomplish a quality finish, including wash formulas, extraction, number of personnel, etc.; the Chicago Dryer Company does not assume any responsibility how this
form is completed or used.
Tip - Flatwork