25
NOVA MIX 2K
English
• Keep the bucket of lubricant liquid full (compatible with the
product being used) in order to prevent the product from drying
on the gun shaft.
H26
H27
H27
• open the two relief valves located on the 2 digital pressure
gauges (
H27
) and open the recirculation valves (
H28
).
H28
Close the machine’s intake taps (
H26
).
CLEANING AFTER WORK ACTIVITIES
Make sure that the machine is not pressurised
before performing any operations which require
the closure or the connection of any machine
component
(filter checks, seal closure, etc.)
.
In “MANUAL OPERATING MODE”, use the electrovalves on the
operator’s panel to make sure that there is no pressure inside
the mixing block. Open and close the three valves on the mixing
block a few times
(see the page regarding “manual controls” in
the manual)
.
ROUTINE MAINTENANCE
Remember to perform a wash cycle before any lengthy periods
of disuse. Periods of disuse can be judged according to the POT
LIFE of the components which are being utilised.
The manufacturer recommends for a wash cycle to be performed
at the end of every working day.
PERIODIC MAINTENANCE (weekly)
Check the machine’s intake filters.
Perform this same check upon all of the filters.
Before opening the filter, remove the filter's tank
(H29) in accordance with the following indications:
- Close the delivery tap (H30);
- Open the filter's drain tap (H28);
This operation will drain any pressure contained
within the filter.
Inspect the unit and make sure that the filter is
not clogged.
H30
H29
H28