Edit. 03 - 06/2019
www.larius.eu
CH 200 AD
6
D
E
TRANSPORT AND
UNPACKING
• Carefully observe the position of the packaging indicated
on the outside by writing or symbols.
• Before installing the machine, prepare an area that is
suitable in size, has the correct lighting, and a clean
and smooth floor.
•
The manufacturer declines all responsibility regarding the
unloading and transport of the machine in the workplace.
• Upon receipt of the machine, verify the packaging is
intact. Remove the machine from its packaging and
check that it has not been damaged during transport.
If damaged components are noted, contact
LARIUS
and the shipping agent in a timely manner. Any damage
noted must be communicated within a maximum of 8
days from receipt of the system.
The communication must be made via registered mail
with return receipt, addressed to
LARIUS
and the
shipping agent.
All operations of unloading and handling of the
machine are the responsibility of the user, who
must be very careful to avoid causing damage or
injury to persons or the machine.
Only specialised and qualified personnel
(forklift
drivers, crane operators, etc.)
and suitable lifting
equipment with a capacity that can support the
weight of the packaging and that complies with
safety regulations should be employed for unload-
ing operations.
Personnel must be equipped with the necessary
personal protection equipment.
The disposal of packaging materials, which is the
responsibility of the user, must be carried out in
compliance with laws in force in the country where
the machine is used.
However, it is good practice to recycle the
packaging materials as much as possible in an
environmentally-friendly way.
SAFETY REGULATIONS
•
THE EMPLOYER MUST EDUCATE PERSONNEL ABOUT
THE RISKS OF INJURIES, OPERATOR SAFETY DEVICES
AND THE GENERAL ACCIDENT PREVENTION RULES
ESTABLISHED BY INTERNATIONAL DIRECTIVES AND
LEGISLATION IN THE COUNTRY WHERE THE MACHINE IS
INSTALLED IN ADDITION TO REGULATIONS CONCERNING
ENVIRONMENTAL POLLUTION.
Carefully read the following instructions in their
entirety before using the machine.
Keep these instructions in a safe place.
The non-authorised tampering with or replacement
of one or more parts that make up the machine, the
use of accessories, tools and consumable materials
that are different from those recommended by the
manufacturer may cause accidents and relieves
the manufacturer from all civil and penal liabilities.
• KEEP THE WORK AREA IN ORDER. DISORDER IN THE
WORKPLACE CAUSES DANGER AND ACCIDENTS.
• ALWAYS KEEP YOUR BALANCE, AVOIDING UNSAFE
POSITIONS.
• BEFORE USE THOROUGHLY CHECK THAT THERE ARE
NO DAMAGED PARTS AND THAT THE MACHINE IS ABLE
TO PROPERLY CARRY OUT ITS FUNCTION.
• ALWAYS OBSERVE SAFETY INSTRUCTIONS AND REGU
-
LATIONS IN FORCE.
• DO NOT ALLOW PERSONS NOT INVOLED IN THE OP
-
ERATION OF THE MACHINE TO ACCESS THE WORK
AREA.
•
NEVER
EXCEED THE MAXIMUM OPERATING PRESSURES
INDICATED.
•
NEVER
POINT THE SPRAY GUN TOWARDS YOURSELF OR
OTHERS. DIRECT CONTACT WITH THE JET MAY CAUSE
SERIOUS INJURY. IN CASE INJURIES ARE CAUSED BY
THE SPRAY GUN JET IMMEDIATELY SEEK MEDICAL
ATTENTION, SPECIFYING THE TYPE OF PRODUCT AB-
SORBED BY THE SKIN.
NEVER
UNDERESTIMATE AN
INJURY CAUSED BY FLUID INJECTION.
• ALWAYS DISCONNECT THE POWER SUPPLY AND
DISCHARGE THE PRESSURE IN THE CIRCUIT BEFORE
PERFORMING ANY TYPE OF INSPECTION OR REPLACE-
MENT OF COMPONENTS OF THE MACHINE.
• NEVER MODIFY ANY COMPONENT OF THE MACHINE.
REGULARLY INSPECT THE COMPONENTS OF THE MA-
CHINE. REPLACE DAMAGED OR WORN PARTS.
•
PERSONNEL MUST CAREFULLY OBSERVE ACCIDENT
PREVENTION REGULATIONS OF THE COUNTRY WHERE
THE MACHINE IS INSTALLED AS WELL AS REGULATIONS
CONCERNING ENVIRONMENTAL POLLUTION.
