Edit. 03 - 06/2019
www.larius.eu
CH 200 AD
15
USE WITH THE TRIBOELECTRIC SPRAY GUN
To use with the triboelectric spray gun, make sure
the selector (H22) is in the "TRIBO" position.
•
Point the spray gun at the object to be painted (recom-
mended distance 15-20 cm) and press the trigger, which
will start to deliver powder, as well as high voltage; the
value of current, expressed in microamperes (max 250 µA)
can be read on the lit indicator (
H28
).
•
Adjust the air pressure to the powder supply pump (
H29
),
by turning the regulator (
H30
) and reading the value ex-
pressed in bar displayed on the pressure gauge (
H23
)
(recommended max values 3-4 bar).
•
Adjust the powder diffusion range of the spray gun using
the knob (
H29
) and reading the value expressed in bar on
the pressure gauge (
H22
), (recommended values 0.5-2 bar);
however, this value must always be less than the supply
air pressure (pressure gauge
H23
).
•
Adjust the "tribo air" pressure using the knob (
H24
) and
reading the pressure value set on the pressure gauge (
H25
).
If the pressure is increased, the triboelectric effect is also
increased.
The electrostatic charge value can be read on the luminous
indicator (
H28
) located on the generator.
At this point, release the spray gun trigger.
Point the spray gun at the object to be pained (recommended
distance 10-20 cm) and press the spray gun trigger, which will
start to deliver powder.
The value of the current expressed in µA (max 10 µA) can be
read on the luminous indicator (
H28
).
Protect the spray gun from all violent mechanical
action. Repeated impacts and shocks of consider-
able intensity, while not altering the outer integrity
of the spray gun, may cause internal damage and
cause the spray gun to become unusable.
