Lapis Roll Laminator PL-LR, Руководство пользователя

Страница: 23 / 47

Configuration settings
The different setting options configure the laminator for specific requirements. This
is carried out either via the control panel or via the interface by means of a
command set. There are exceptions, whereby access is only possible via one or the
other method.
Simultaneous switching on of the device and pressing of the key
resets all settings to the standard values. The set-up values are an
exception to this.
CLEAR
Menu: SETTING / Temperature
Command: <ESC>T d <CR>
Setting the thermal energy for the heated roller for lamination. The correct
temperature must be experimentally determined with consideration to the
lamination speed, the film and the document. The presetting must be considered
a guideline value.
Setting range:
150...180...190 degree C
Menu: SETTING / Lamination Speed
Command: <ESC>G d <CR>
Setting of the transport speed of the document during lamination. The correct
speed must be experimentally determined with consideration to the lamination
temperature, the laminate film and the document. The presetting must be
considered a guideline value.
In order to carry out a test it is possible to start the motor via
Setting range:
4...8...20 mm/s
Menu: SETTING / Delay Heatroller
Command: <ESC>D d <CR>
Setting the waiting time, once the heated roller has lowered and lies on the
document. Only after this time does the actual lamination start.
Setting range:
0...200...2000 ms
SETTING
23
4