Lapis Roll Laminator PL-LR, Руководство пользователя

Страница: 12 / 47

Inserting film
2 1
3
4
4
5
There is a risk of burning on the safety guard for the heated roller (5)
Newly inserted patch film must be subsequently synchronised. This is not
necessary in the case of holographic film without an index mark. The process
therefore differs very slightly. Refer also in this regard to the menu under Device.
When inserting or exchanging patch film proceed as follows:
• Open housing cover, if necessary unlock the lock first
• Switch off the device and let it cool down
• Release the heated roller interlocking. To do so push the lever (3) up.
• When exchanging the film additionally empty carrier rollers (1,2)
• Switch on the device. An error message is displayed.
• Slide the film roll onto the unwinding carrier roller (1) until it reaches the
limit stop.
• Slide an empty film core onto the winding carrier roller (2) until it reaches the
limit stop.
• Insert the film in accordance with the drawing shown above. Attach the start
of the film to the empty core with adhesive tape.
• Close the heated roller interlocking. To do so push the lever (3) down.
• Transport film with to the first patch and when doing so check that the
film runs correctly and crease-free.
• Delete error message with . The film is re-synchronised.
CLEAR
The first index mark on the film should lie between the two sensors (4),
in order that no patch is lost.
12
2