Lapis Roll Laminator PL-LR, Руководство пользователя

Страница: 28 / 47

Reset
Befehl: <ESC>!!<CR>
Der Laminator wird neu resetiert. Der Vorgang entspricht einem Neustart nach
Power On. Nicht im Makro gespeicherte Einstellungen gehen verloren.
Reset
Befehl: <ESC>!!<CR>
Der Laminator wird neu resetiert. Der Vorgang entspricht einem Neustart nach
Power On. Nicht im Makro gespeicherte Einstellungen gehen verloren.
Menu: SETUP / Pass Position
Stipulation of the passport position at the heated roller. This is optimally set in the
factory and does not require adjustment.
Setting range:
120...216...360 x 1/24mm
Menu: SETUP / Separate Position
Stipulation of the position at which the film is separated from the document after
lamination by way of a separator. This is optimally set in the factory and does not
require adjustment.
Setting range:
5...23...60 mm
Menu: SETUP / Heating Cycle
This setting influences the switch-on cycle within the heating control. Too high a
value leads to an overshooting of the temperature range. This parameter is
optimally set in the factory and does not require adjustment.
Setting range:
250...750...1500 mm
Menu: SETUP / Heating Offset
This setting influences the control algorithm of the heating control for the heated
roller. The value is optimally set in the factory and does not require adjustment.
Setting range:
0..5 Grad Celsius
SETUP
28
4
Menü: SETUP / Lami Length Corr
Correction of lamination length in “Settings/LaminationLength”.
Einstellbereich:
0...10...20 -10mm