4: Using DeviceInstaller
UDS1100 User Guide
21
Assigning the IP Address: Serial Port Login
To assign the IP address and other network settings using a serial connection
:
1. Connect a console terminal or a PC running a terminal emulation program to the
unit's serial port. The default serial port settings are
9600 baud, 8 bits, no parity, 1
stop bit, no flow control
.
2. To enter Setup Mode, cycle the unit's power (power off and back on). After power-up,
the self-test begins and the red Diagnostic LED starts blinking.
You have
one
second
to enter three lowercase
x
characters.
Note:
The easiest way to enter Setup Mode is to hold down the
x key at the
terminal (or emulation) while powering up the unit.
3. Select
0
(Server Configuration) and follow the prompts until you get to
IP address
.
4. Enter the new IP address, subnet mask, and gateway (if applicable).
5. Do one of the following:
Continue with
5: Configuration via Telnet or Serial Port (Setup Mode).
Select
9
to save and exit Setup Mode. The unit performs a power reset.
