7: Action Settings
PremierWave® XN Intelligent Gateway User Guide
72
To Configure Action Settings
Using Web Manager
To view Action status information, click
Action
on the menu and select
Status
.
To modify Action information, click
Action
on the menu and select a specific action from the
drop-down menu.
Alarms and Reports (on page 71)
lists the options.
Using the CLI
To enter the eth0 link state change command level:
enable -> config -> action ->
eth0 link state change
To enter the wlan0 link state change command level:
enable -> config -> action ->
wlan0 link state change
To enter device temperature change command level:
enable -> config -> action ->
device temperature change
To enter on scheduled reboot command level:
enable -> config -> action -> on
scheduled reboot
FTP Put
Use FTP Put to put a file on configured FTP server.
Filename will be used to upload to remote FTP server. The IP
Address
or hostname
is the FTP server to connect. Port number is port on which FTP server is listening on.
Use Protocol to connect to FTP server. FTPS is a SSL encrypted communication
channel and SSL Trusted Authorities must be setup with FTP server SSL certificate.
Username is used to logon to FTP server. If FTP server does not require
authentication, use anonymous. Password is used to logon to FTP server. If FTP
server does not require authentication, a common practice is to use user’s email
address. If the alarm stays on or off longer than the
Reminder Interval
, another FTP
Put is performed. In
Sequential
mode, connections will be attempted starting with
number 1 until a connection is successful. In
Simultaneous
mode, all possible
connections will be made.
HTTP Post
Use HTTP Post post to configured HTTP server.
The URL appears behind the HTTP server IP address or hostname. E.g. http://
some_http_server/some_url The IP
Address
or hostname is the HTTP server to
connect to. Port number is the port which HTTP server is listening on. Use Protocol
to connect to HTTP server. HTTPS is a SSL encrypted communication channel and
SSL Trusted Authorities must be setup withHTTP server SSL certificate. Username
used to logon to HTTP server if authentication is required. Password used to logon to
HTTP server if authentication is required. If the alarm stays on or off longer than the
Reminder Interval
, another HTTP Post is performed. In
Sequential
mode,
connections will be attempted starting with number 1 until a connection is successful.
In
Simultaneous
mode, all possible connections will be made.
SNMP Trap
Use SNMP Trap to send SNMP trap to configured trap destinations.
The contents of
Alarm Message
are included when an alarm SNMP trap is sent. If
the alarm stays on longer than the
Reminder Interval
, another alarm SNMP Trap is
sent. The contents of
Normal Message
are included when a normal SNMP trap is
sent. If the alarm stays off longer than the Reminder Interval, another normal SNMP
Trap is sent.
Action Settings
Description
