10
The network parameters for the network port must first be set up through the
serial terminal port before the ConsoleServer 800 may be reached remotely.
See section 4.4 for more information.
Installation:
Materials:
•
ConsoleServer 800 network port
•
network
point-of-connection
•
RJ45-terminated Cat 5 cable (standard LAN cable)
1.
Configure the ConsoleServer network parameters to the desired values as
outlined in section 4.4.
2.
Configure the network point-of-connection. It must be manually set to 10
Mbits, half-duplex, with no auto-negotiation.
3.
Connect the ConsoleServer network port to the network using a standard
LAN cable.
4.
Check the status lights at each end of the connection. Both should
indicate a good link. Try reaching the IP address assigned to the
ConsoleServer by using
PING
or
TELNET
. If there is a problem, check the
network configuration.
3.7
Connecting the Modem Port
An optional modem port is available for the ConsoleServer 800. The modem
may be installed at the factory or can be ordered separately for later installation.
See section 3.8 for the procedure to install a modem card in a previously
purchased system.
ConsoleServer 800 modem port
