Landoll 2411, Руководство оператора

Страница: 113 / 116

F-1130-2304 6-1
TABLE OF CONTENTS Chapter 6
Troubleshooting Guide
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your 2411 Weatherproofer. Follow all safety precautions
stated in the previous sections when making any
adjustments to your machine.
PROBLEM PROBABLE CAUSE SOLUTION
UNEVEN DEPTH Unit not level when under power in the field Level unit front to rear
(See “Leveling
(Front-to-Rear)” on page 4-6.)
Excessive disc gang depth or down
pressure Reduce machine depth.
Tire pressure too low Check inflation.
Unit not level front to rear Adjust unit to be level.
UNIT SIDE DRAFTS OR MOVES SIDE
TO SIDE Lift wheels not carrying enough weight Adjust depth stop and raise implement.
Unit not level front to rear Adjust unit to be level.
SHANKS PLUGGING WITH RESIDUE Unit not level Level machine
(See “Leveling
(Front-to-Rear)” on page 4-6.)
Discs not cutting residue Adjust machine depth.
SHANKS NOT PENETRATING Unit not level Level unit front to rear
(See “Leveling
(Front-to-Rear)” on page 4-6.)
Points worn Install new points.
WHEEL BEARING FAILURE Triple-lip seals not installed correctly Install seals with the lips pointing outward
away from the hub.
DISC BLADES LOOSE AND/OR
SHEARING ROLL PIN Gang not tightened properly Retighten gang shafts to 1200-1500 ft-lbs.
If gangs have ran loose, gangs may
require disassembly to remove soil to
properly torque gang shafts. Replace
any worn components, shafts/spools,
etc.
HYDRAULIC - ENTIRE UNIT SETTLING Depth stop valve not working Repair valve
DISC GANG PLUGGING Operating depth too deep Raise unit or raise disc gangs..
Conditions too wet Wait until conditions more favorable.
DISC GANG WILL NOT TURN OR
PUSHES SOIL Depth set too deep for loose or wet
conditions Raise implement or wait until conditions
are more favorable.
Gang bearing failure Replace bearing
UNIT NOT LEVEL, LEAVING RIDGE ON
OUTSIDE OF UNIT Unit not level front to rear, front running too
deep Adjust unit to be level
Wings not level with center frame Adjust side to side level. Wings should
typically be set even with center
section
Operating speed too fast, front gang
moving soil past rear gang Slow down to proper operating speed for
field conditions.
HARROW BUNCHING RESIDUE Harrow too aggressive Use lower tine tooth angle and/or raise
harrow
HARROW DRAGS GROUND WHEN
TRANSPORTING Operating depth set too low Raise harrow height
Disc leveler linkage not set correctly Reposition in lower leveler hole
LIGHTS DO NOT WORK Harness or lamp connection unplugged Check all harness/lamp connections to
verify that everything is properly
connected.
7 prong Connector Fully Insert on clean connection