Land Pride RC4710, Руководство оператора

Страница: 25 / 72

Section 1: Assembly & Set-up
RC(L)4710 & RCM(L)4710 Rotary Cutters 334-863M 7/31/20
21
Table of Contents
Fold Lock Lugs Set-up
Refer to Figure 1-18:
If your cutter comes equipped with a dual-action fold
cylinder set up, the fold lock lug plates (#5) do not need to
be flipped around. See Figure 1-19 .
If your cutter comes equipped with a single-action fold
cylinder set up, perform the following steps to flip the four
fold lug plates around. See
Figure 1-20
.
1. With the wing down and on a level surface, remove all
5/8" hex nuts (#1), lock washers (#2), flat washers
(#3) and 5/8"-11x1 3/4" bolts (#4) from wing deck. Set
hardware aside for re-use.
2. On wing deck, flip the fold lock lugs (#5) length wise
as shown.
3. Re-install 5/8" hex nuts (#1), lock washers (#2), flat
washers (#3) and 5/8"-11x1 3/4" bolts (#4). Hand
tighten nuts (#1).
4. Once all hardware has been reinstalled, start the
tractor, and raise the wing. Then shutdown the tractor
without relieving hydraulics.
5. Insert transport pin as shown in
Figure 1-16 on
page 20 .
6. Tighten all nuts (#1) on wing deck to correct torque.
Refer to “Torque Values Chart for Common Bolt
Sizes”
on page 65 .
Fold Lock Lugs Set-up For Dual-Acting Cylinder
Figure 1-19
Fold Lock Lugs Set-up For Single-Acting Cylinder
Figure 1-20
70545
Tapered
End
70546
Tapered
End
Fold Lock Lugs
Figure 1-18
70544