4
SPECIFICATIONS
INSTALLATION
CARBON DIOXIDE (CO
2
) SUPPLY
Min Pressure
: 70 PSIG (0.483 MPA)
Max Pressure
: 80 PSIG (0.552 MPA)
FITTINGS
Carbonated Water Inlet
: 3/8 inch barb
Plain Water Inlet
: 3/8 inch barb
Brand Syrup Inlets
: 3/8 inch barb
DIMENSIONS
Width
: 30.0 inches (762 mm)
Depth
: 31.0 inches (787 mm)
Height
: 37.25 inches (946 mm)
WEIGHT
Shipping
: 335 lbs (152 kg)
Empty
: 275 lbs (125 kg)
Ice Capacity
: 250 lbs (113.6 kg)
Ice Dispensable
: 185 lbs (84 kg)
ELECTRICAL
115 VAC / 60 Hz / 3.0 Amps
PLAIN WATER SUPPLY
Min Flowing Pressure
: 75 PSIG (0.517 MPA)
CARBONATED WATER SUPPLY
Min Flowing Pressure
: 25 PSI (0.172 MPA)
Max Static Pressure
: 50 PSI (0.345 MPA)
Sensation - 4800
This unit emits a sound pressure level below 70 dB
Unpack the Dispenser
1.
Set shipping carton upright on the floor then cut package
banding straps and remove.
2. Open top of carton and remove interior packaging.
3.
Lift carton up and off of the unit.
4. Remove plywood shipping base from unit by moving unit so
that one side is off the counter top or table allowing access
to screws on the bottom of the plywood shipping base.
Inspection of Drain Spider
If unit is to be transported, it is advisable to leave the
unit secured to the plywood shipping base.
NOTE
5. Remove accessory kit and loose parts from ice compartment.
Inspect unit for concealed damage. If evident, notify
delivering carrier and file a claim against the same.
NOTE
6. If leg kit has been provided, assemble legs by tilting unit.
The drain spider is located to the right side near the
front of the bin under the ice shroud. The coldplate has
a cavity designed to hold the drain spider. During
shipment, the drain spider may become dislodged from
its original position. Prior to installing the unit, ensure
the drain spider is in the correct position.This will
prevent drain clog issues. Inspect the lower bin area
and reach under the shroud to ensure the drain spider
is secure in the coldplate cutout. If the spider is not in
place, proceed with the following steps.
NOTE
1. Remove agitator clip and pin from agitator bar.
2. Remove agitator bar from paddle wheel.
3. Remove paddle wheel.
4. Remove ice shroud by lifting back then out of bin.
5. Locate drain spider and reinstall in the coldplate cavity where
drain line exits.
6. Reinstall all components. Ensure agitator clip is locked.
READ THIS MANUAL
This manual was developed by the Lancer Corporation as a reference for the owner/operator and installer of this dispenser. Please
read this guide before installation and operation of this dispenser. If service is required please call your Lancer Service Agent or Lancer
Customer Service. Always have your model and serial number available when you call.
Your Service Agent:
Service Agent Telephone Number:
Serial Number:
Model Numer:
Installation Date:
