Fusion Tablesaw
25
Changing
the Belt
:
1. Unplug the tablesaw!
2. Remove all throatplates, blades, and
blade accessories.
3. Remove the motor cover.
4. Remove the dust shroud.
5. Loosen the Belt adjustment bolt and
loosen belt by raising motor.
6. Remove belt.
NOTE
: you may need to
lower the arbor height to access the
belt.
7. Replace belt.
Use Caution:
DO NOT
OVERTIGHTEN BELT! The weight of
the motor is adequate to put enough
tension on the belt. Only tight enough to
prevent slippage.
Belt Adjustment
bolt
Accessing the
Belt
WARNING: MAKE SURE SAW IS UNPLUGGED.
NOTICE:
The drawing shown is with the top of the
table removed.
AVOID
removing the table top. The
belt can easily be changed without removing the
table top
Accessory Adjustments
Insert Block Adjustments (For all Safety Accessories):
The Riving knife, blade guard, or splitter must be aligned with the blade to be used affectively. The riving knife should only be used with blades
specified on the riving knife. To adjust the position of the blade safety attachments, relative to the saw blade:
NOTE:
if the cam action lever does
not lock or is too hard to lock – adjust the ½” nut on the back side of the cam action axil. You will need to remove the motor cover
Loosen the two middle setting bolts. These
two bolts fasten the assembly in-between the
set screws and the arbor block.
Adjust the set screws as needed to correct an out
of align blade attachment. Do small adjustments
and check.
As Adjustments are made, the blade attachments
will translate, not rotate, by design. This ensures
that the workpiece will not get held up.
CHECK
COMPONENTS BEFORE EVERY CUT.
Riving Knife Adjustments:
After changing a saw blade, always check that
the riving knife is correctly set!
The distance of the riving knife from the
gear rim must be between 3 mm and 8 mm.
The highest point of the riving knife must
be set at least 2mm beneath the topmost
tooth.
The riving knife must be at least 0.2
mm thicker than the main saw blade.
Check that the saw blade clamping
system is tight before operating the machine!
Dust Collector:
Содержание CEF236230175
