laguna CEF236230175, Руководство по установке и обслуживанию

Страница: 24 / 45

Fusion Tablesaw
24
Arbor and Tilt Adjustments
Adjusting the Blade Tilt Limits
You can check the arbor (blade) tilt limits with an angle finder or 45-degree triangle. If these limits are not within 0 degrees and 45 degrees, use
the following steps to adjust.
1. Unplug the tablesaw!
2. Remove the motor cover.
3. Remove the tool storage cover.
4. Locate tilt adjustment screws.
5. Adjust as needed.
6. Adjust the scale and indicator as
needed.
.
2. remove motor cover 3. remove tool storage cover
WARNING: MAKE SURE SAW IS UNPLUGGED .
To access the left side tilt limit adjustment screw,
remove the motor housing cover using a #2
Philips head driver. There are 4 screws in total
holding on the motor cover.
To access the right-side tilt adjustment screw,
remove the tool storage using a #2 Philips head driver.
There are 4 screws in total holding on the tool storage
box.
4. Locate Tilt Adjustment
screw
5. Adjust as needed 6. Adjust scale (if needed)
Locate the tilt adjustment screw. Screw it in to
expand the tilt range slightly.
Locate the tilt adjustment screw. Screw it in to
expand the tilt range slightly
.
Adjust the scale and tilt indicator on the cabinet if
needed.
Adjusting the Belt:
It is good practice to check the tension of the belt often to ensure that the saw is performing properly. If the tablesaw blade is slipping or is feeling
underpowered, you may need to tighten the belt. To do so, follow the steps below.
Remove the motor cover Locating Belt Adjustment bolt
1. Unplug the tablesaw!
2. Remove the motor cover.
3. Locate belt adjustment bolt.
4. Tighten or loosen with weight of motor.
Use Caution:
DO NOT
OVERTIGHTEN BELT! The weight of
the motor is adequate to put enough
tension on the belt. Only tight enough to
prevent
slippage.
WARNING: MAKE SURE SAW IS UNPLUGGED.
To access the motor, remove the motor housing
cover using a #2 Philips head driver. There are 4
screws in total holding on the motor cover.
To adjust the belt, set blade to 0° on tilt scale, then
raise or lower blade to approximately 2" above table.
Loosen the belt adjustment bolt. With the bolt loose,
Raise or lower the motor so that the belt is tight.
Use Caution:
From the factory, the tilt
limits are pre-set to be between 0 and 45
degrees tilt to the left. Adjusting this limit will
slightly increase or decrease that amount which
may cause zero clearance throat plate or fence
to interfere. Adjusting these limits should only be
done to set the tilt limits to 0 and 45 degrees