laguna CEF236230175, Руководство по установке и обслуживанию

Страница: 28 / 45

Fusion Tablesaw
28
CROSS CUTTING
Cutting against the grain, to shorten the length of a board is crosscutting. With
some smaller sized and rectangular pieces, you often have the choice of ripping or
crosscutting. Always use the miter gauge, when crosscutting; never cut a piece
unsupported. The miter gauge may be used in either slot, but most operators
prefer the left groove for typical work. When the blade is tilted for bevel cutting, use
the table slot that does not cause interference with your hand or the saw blade
guard.
To begin crosscutting, place the work on the miter gauge and, with the motor OFF,
slide it up close to the blade to align the outer edges of the teeth with your cut mark
Fig.
Keep a firm grip as you pull the miter gauge and the wood back away from the
blade. Lower the blade guard, turn on the saw and make the cut. When the work is
cut through, move one or both cut pieces.
If long enough to handle without danger immediately off to the side, away from the
turning blade. Turn off the motor
BEVEL CROSS CUTTING
This procedure is the same as cross cutting except that the blade is set to an
angle other than 0. After changing the bevel angle, verify the alignment of the
guard and splitter and verify that there is clearance with the saw blade
MITRE CUTS
This operation is the same as cross cutting, except the miter gauge is set to
an angle other than 0. Hold the work piece firmly against the miter gauge
and feed the workpiece slowly into the blade to prevent it from moving during
the cut.
Warning: When cross-cutting round
stock it is necessary to secure the
workpiece against rotation by using a
suitable jig or holder and to use a suitable
saw blade