Running and adjusting the machine.
Cleaning the machine.
The machine is shipped with the non-painted surfaces protected from rust by a
film of grease.
The grease must be removed with WD40 or similar as it attracts saw dust and
dirt. The surfaces should then be coated with a Teflon lubricant or similar.
Teflon tends to dry and will not attract saw dust and dirt.
Test Run
Now that the assembly is complete it is time to conduct a test run.
During the test run you will check the following points.
1.
Motor starts and runs smoothly.
2.
That the stop buttons function correctly.
Before you run the machine check the following.
1.
All the tools have been removed from the machine.
2.
All the guards are in place.
3.
You are wearing the appropriate safety equipment.
4
. You have read and understood the instruction manual.
Green start button
Note.
If any of the below functions fail to operate correctly, the fault must be
corrected prior to continuing to the next test. Any investigation to find or
correct a fault must be conducted with
the power disconnected.
Note.
The stop button, when pressed in,
will remain in the off position until reset.
To reset the stop button twist. Check that
the stop button is in the out position prior
to conducting the below tests.
1.
Start the machine by pressing the
green start button.
The machine should run smoothly with
little or no vibration.
2.
Press the red stop button. The machine
should slow down and stop.
Red stop button
20
