External mobility kit wheel assembly
6.
To operate the mobility kit, press the
external mobility kit wheel lever down.
Move the machine to the required
location, and then lift the lever to
disengage the wheel from the floor.
Fitting the in and out feed tables.
1.
Attach the in and out feed tables to the
main table with the clamping bolts. Do
not over tighten, as the tables will need to
be adjusted.
2.
Adjust the table level to the main table
by tapping with a non-metal mallet.
Never hit the tables with a hammer as
they are cast iron and will break.
3.
Using a straight edge, adjust the
jacking screws so that the table it is
parallel and level with the main table.
In and out feed tables
4.
Fully tighten the table with the
clamping screws. Recheck the tables for
level and parallel. If fine adjustment is
required, repeat the procedure.
Jacking screws
Clamp screw
Straight edge
15
