Where to locate your Machine.
Before you remove your machine from the pallet, select the area where you
will use your machine. There are no hard and fast rules for its location but,
below are a few guidelines.
1.
There should be an area at the front and back of the machine suitable for
the length of wood that you will be machining.
2.
Adequate lighting. The better the lighting, the more accurate and safely
you will be able to work.
3.
Solid floor. You should select a solid flat floor, preferably concrete or
something similar.
Packaging box
4.
Close to power source and dust collection.
Unpacking your machine.
To unpack your machine, you will need tin
snips, knife and a wrench.
1.
Using the tin snips, cut the banding that is
securing the machine to the
Pallet [if fitted].
WARNING: EXTREME CAUTION
MUST BE USED BECAUSE THE
BANDING WILL SPRING AND COULD
CAUSE INJURY.
2
. Lift the box off and discard.
Machine parts
3.
Using the knife, cut the plastic wrap from
the top. The accessories that were ordered
could be attached to the side of the machine
and extreme
caution must
be taken that
the parts do
not fall and
cause injury or
damage.
Remove them
and set aside.
Extension tables
Side panel
12
