Laguna Tools Fusion 3, Руководство пользователя

Страница: 23 / 40

Fusion Tablesaw
© 10/2017, Laguna Tools, Inc.
21
Changing the Belt:
1. Unplug the tablesaw!
2. Remove all throatplates, blades, and
blade accessories.
3. Remove the motor cover.
4. Remove the dust shroud.
5. Loosen the Belt adjustment bolt and
loosen belt by raising motor.
6. Remove belt. NOTE: you may need to
lower the arbor height to access the
belt.
7. Replace belt.
Use Caution:
DO NOT OVERTIGHTEN
BELT! The weight of the motor is
adequate to put enough tension on the
belt. Only tight enough to prevent
slippage.
WARNING: MAKE SURE SAW IS UNPLUGGED.
NOTICE: The drawing shown is with the top of the
table removed. AVOID removing the table top. The
belt can easily be changed without removing the
table top
Accessory Adjustments
Insert Block Adjustments (For all Safety Accessories):
The Riving knife, blade guard, or splitter must be aligned with the blade to be used affectively. The riving knife should only be sued with blades
specified on the riving knife. To adjust the position of the blade safety attachments, relative to the saw blade: NOTE: if the cam action lever does
not lock or is too hard to lock – adjust the ½” nut on the back side of the cam action axil. You will need to remove the motor cover
Loosen the two middle setting bolts. These
two bolts fasten the assembly in-between the
set screws and the arbor block.
Adjust the set screws as needed to correct an out
of align blade attachment. Do small adjustments
and check.
As Adjustments are made, the blade attachments
will translate, not rotate, by design. This ensures
that the workpiece will not get held up. CHECK
COMPONENTS BEFORE EVERY CUT.
Blade Guard Adjustments:
The blade guard can be partially disassembled by unscrewing the thumbscrew at the top of the blade guard assembly. The guards should only be
taken off to perform safe cuts that otherwise would be impossible with the blade guard on.
Shown is the blade guard in the fully
assembled position.
Shown is the blade guard in the held assembled
position with the anti-kickback pawls still attached.
To remove the acrylic guards, unscrew the thumb
screw located on the top of the frame. Slide the
guards away and apart.
Belt Adjustment bolt Accessing the Belt