Laguna Tools Fusion 3, Руководство пользователя

Страница: 14 / 40

Fusion Tablesaw
12
© 10/2017, Laguna Tools, Inc.
Loose Parts & Overview
Your new machine has been mostly assembled at the certified ISO 91001 factory where it was made. Some parts must be assembled by
the purchaser. Please read all steps first before proceeding with step one.
(5) M8x1.5+ lock washer
+ nut
(5) Square Head
M8x1.5+ nut
[See explanation of steps on the following pages.]
General Setup
1. Attach the short rear fence support
2. Attach the long rear fence support
3. Level the rear rails and fasten
4. Attach T-Slot bolts to front table
5. Insert long front rail fence support
6. Insert short front rail and switch
7. Join front fence supports
8. Align the entire front rail to blade mark
9. Level and fasten the front rail
10. Insert fence
11. Level the saw by adjusting casters
Use the supplied wrench and Alan key to loosely
fasten (2) bolts, lock washers, washers, and nuts
to the short rear fence guide and the back left of
the table. STOP BEFORE TIGHTENING: Keep
bolts loose until entire rail assembly is in place to
properly level rail.
Repeat step 1 for the longer rear fence section with
(3) bolts, lock washers, washers, and nuts. Use the
same assembly diagram in Step 1.
NOTICE: If the fence hooks are not yet installed,
now is a good time to do so.
To level the rear fence with the table top, place a
ridged straight edge on top of the rails. Apply
downward force at both arrow indicators and
simultaneously tighten the bolts with the supplied
Allen key and wrench.
Loosely fasten the (5) square headed bolts, (5)
washers, and (5) nuts. A couple revolutions of the
bolt will be tight enough. Prepare to insert the (2)
aluminum front rail sections.
Insert the long Front Rail. STOP BEFORE
TIGHTENING: Keep these bolts loose until the
entire rail assembly is in place to properly level the
rail.
1.
2.
3.
4.
5.
6. 7. 8. 9.
10.
11.
12.
1. Attach short rear fence support 2. Attach long rear fence support
4. Attach T-slot bolts to front table
5. Insert the long front fence support
3. Level the rear rails and fasten
Fence hooks (step 2)