Laguna Tools Fusion 3, Руководство пользователя

Страница: 18 / 40

Fusion Tablesaw
16
© 10/2017, Laguna Tools, Inc.
Installing A Dado Set
1. Un-plug the tablesaw!
2. Remove any blade guards, riving knifes, or
throat plates to access the blade.
3. Set the arbor tilt to 0 degrees and lock.
4. Raise saw to highest position.
5. Insert dado blade and chippers as shown.
6. Tighten down arbor nut with arbor wrench.
7. Re-install and lock the dad throat plate.
CAUTION: Make sure the teeth of the blade
are facing the front of the saw as shown.
WARNING: MAKE SURE SAW IS UNPLUGGED.
Install dado set as shown to prevent chipper
jamming.
Cutting A New Zero Clearance Throat Plate (For Dado Set)
Uncut zero clearance throat plates are available for purchase. This is a dangerous process; safety glasses and extreme caution are required.
WARNING: Make sure the throat plate is locked and not able to move by adjusting the set screws. WARNING: Make sure to remove blade
accessories during this procedure as they can interfere, set the cam action lock to the lock position.
1. Un-plug the tablesaw!
2. Set tilt to zero degrees and lock.
3. Remove throat plate, riving knife, blade
guard, or splitter.
4. With the blade installed set the arbor
height to the lowest position.
5. Install the new throat plate.
6. Lock the throat plate and adjust the set
screws such that the throat plate has
zero play and is solid with the table.
7. Plug in the tablesaw.
8. SLOWLY rise the blade in and through
the throatplate to the desired clearance.
9. Re-adjust the throat plate back to
operation height.
WARNING: MAKE SURE SAW IS UNPLUGGED.
With the saw unplugged, set the arbor tilt to 0
degrees and lock the arbor tilt mechanism so it
cannot move. It is wise to double check that the
blade is 90 degrees to the table if this is a new
saw. Set arbor height to lowest position and install
new throat plate.
Lock the throat plate in position and screw in the
Alan set screws so that the table tries to force
away and comes in contact with the locking
mechanism. This will ensure that the throat plate
will not move and stays in the same location during
the next steps.
Give power to the table saw and SLOWLY
raise the blade through the new throat plate.
NOTICE: Use a respirator! Cutting the
throatplate may contain particles that are
harmful to the human body.
As the blade rises, the throatplate section will cut
away. Stop the process at the desired blade height
for application with the blade or dado set.
Finished process.
Loose parts Blade close up
Set Blade tilt to zero and lock Lock throat plate and set screws
Slowly Raise blade Completed dado throat plate Slowly Raise Blade