Laguna Tools Fusion 3, Руководство пользователя

Страница: 22 / 40

Fusion Tablesaw
20
© 10/2017, Laguna Tools, Inc.
Arbor and Tilt Adjustments
Adjusting the Blade Tilt Limits
You can check the arbor (blade) tilt limits with an angle finder or 45-degree triangle. If these limits are not within 0 degrees and 45 degrees, use
the following steps to adjust.
1. Unplug the tablesaw!
2. Remove the motor cover.
3. Remove the tool storage cover.
4. Locate tilt adjustment screws.
5. Adjust as needed.
6. Adjust the scale and indicator as
needed.
Use Caution:
From the factory, the tilt
limits a pre-set to be between 0 and 45
degrees tilt to the left. Adjusting this
limit will slightly increase or decrease
that amount which may cause zero
clearance throat plate or fence to
interfere. Adjusting these limits should
only be done to set the tilt limits to 0
and 45 degrees.
WARNING: MAKE SURE SAW IS UNPLUGGED.
To access the left side tilt limit adjustment screw,
remove the motor housing cover using a #2 Philips
head driver. There are 4 screws in total holding on
the motor cover.
To access the right-side tilt adjustment screw,
remove the tool storage using a #2 Philips head
driver. There are 4 screws in total holding on the
tool storage box.
Locate the tilt adjustment screw. Screw it in to
expand the tilt range slightly.
Locate the tilt adjustment screw. Screw it in to
expand the tilt range slightly
.
Adjust the scale and tilt indicator on the cabinet if
needed.
Adjusting the Belt:
It is good practice to check the tension of the belt often to ensure that the saw is performing properly. If the tablesaw blade is slipping or is feeling
underpowered, you may need to tighten the belt. To do so, follow the steps below.
1. Unplug the tablesaw!
2. Remove the motor cover.
3. Locate belt adjustment bolt.
4. Tighten or loosen with weight of motor.
Use Caution:
DO NOT OVERTIGHTEN
BELT! The weight of the motor is
adequate to put enough tension on the
belt. Only tight enough to prevent
slippage.
WARNING: MAKE SURE SAW IS UNPLUGGED.
To access the motor, remove the motor housing
cover using a #2 Philips head driver. There are 4
screws in total holding on the motor cover.
To adjust the belt, set blade to 0° on tilt scale, then
raise or lower blade to approximately 2" above
table. Loosen the belt adjustment bolt. With the bolt
loose, Raise or lower the motor so that the belt is
tight.
2. remove motor cover 3. remove tool storage cover
2. Locate tilt adjustment screw 3. Adjust scale (if needed) 4. Locate Tilt Adjustment screw
Remove the motor cover Locating Belt Adjustment bolt