Lada GRANTA, Руководство пользователя

Страница: 88 / 140

with the pressure lower than norma-
tive results in worsening of car ride
and handling, braking performance
as well as impacts the increase in fuel
consumption and reduces tire life.
If indicator turned on, it is neces-
sary to stop the car following all pre-
cautions, check the tire status and
put their pressure level to the normal
status. Tire pumping shall be done
with ignition on with the pressure
2,2–2,3 atm after this the indicator
shall turn off. If the indicator remains
on, it is necessary to recheck and
pump other car tires till the indicator
turns off. After the indicator turns off
it is necessary to lower the tire pres-
sure to the values recommended by
the car manufacturer. If it is not pos-
sible to secure the appropriate tire
pressure it is necessary to replace
the disabled wheel by spare one.
Attention! Spare wheel is not
equipped by TPMS sensor and in
case of its usage the indicator will be
on, it is necessary to drive carefully
till the elimination of malfunction.
Pay attention that the application
of TPMS system does not mean that
there is no need for correct servicing
of tires and maintaining the appropri-
ate pressure in them even if the
decrease of the level is not enough to
turn the TPMS indicator on.
The indicator is also used to
alarm about failure in the TPMS sys-
tem. When the system detects failure
the indicator twinkling 5 times with
the frequency Hertz then continues
permanent lighting.
The indication on the failure in the
TPMS system is done each tome
when ignition turns on till the failure
exists. When the failure indicator
turned on, the system probably will
not be able to detect or indicate low
pressure in the tires as it is aimed for.
The failure in TPMS system could be
caused by different reasons includ-
ing the installation or replacement of
tires or wheels.
Always check the TPMS failure
indication after the replacement of
one or several tires, wheels or the
place of their installation in the car to
be sure in operation ability of the
TPMS system.
Replacing the wheels
To replace wheels:
– put the vehicle on a level surface
and brake it with the parking brake
and the first gear on;
– take the spare tire and tools;
– remove the wheel cover
(in the
design variant) ;
– loosen the replaced wheel
fastening bolts with combination
wrench 2 (Fig. 54) for one turn;
– set lifting jack 1 so that the recess
in the jacking pad is inserted to the
edge of the sill closer to the wheel that
is replaced, and the foot of the jack is
86
Fig. 55. Packing the spare wheel
Fig. 54. Lifting the vehicle when
replacing the wheels