Lada GRANTA, Руководство пользователя

Страница: 67 / 140

For this purpose:
1. Check and adjust air pressure
in the tires (see Table 3).
2. Check the oil level in the
crankcase, and, if necessary, adjust it.
3. Check the levels of coolant,
brake and washer fluids and, if nec-
essary, adjust them.
4. Check the bulbs of the exterior
lights for their normal operation and
cleanliness.
5. Check the wiping system oper-
ation.
6. Check the mirrors, the seats
and the seat belts for their proper
installation.
7. Check the service brake system
(no failure of the brake pedal) and the
parking brake system (handbrake
lever lock) for normal operation.
Traces of oils and fluids under the
vehicle mean that its components
and assemblies are not sealed. In
this case, you must contact any cer-
tified SSNE for troubleshooting and
the reasons for their appearance
removal.
ATTENTION!
Without putting it off, repair
detected failures at the certified
SSNEs.
Driving position behind
the whee l
Warning
Safe driving technique largely
depends on the driver's correct
position. Correct driving position –
the driver rests on the seat back
tightly enough, his/her legs are
not fully spread for full pedal trav-
el, and both arms, slightly bent at
elbows, hold the upper part of the
steering wheel. The body position
should be firm but not strained –
it prevents fast exhaustion.
Engine start
These recommendations provide
starting of properly operating engine
with storage battery, charged by at
least 75%, with engine oil of SAE vis-
cosity grade, corresponding to envi-
ronmental temperature (see Appox.
with gasoline of volatility class for
winter period, depending on climatic
area of application.
1. Before starting the engine,
insert the key into the ignition switch,
press the brake pedal, depress the
clutch pedal until it stops, shift the
gear change lever to the neutral
position.
2. Switch on the ignition, make a
pause for a few seconds so that the
electric petrol pump has time to
increase the pressure in the fuel rail
up to operating value.
ATTENTION!
During starting the engine, do
not press the accelerator pedal.
Cold start of the engine is opti-
mized to the ambient tempera-
ture minus 27 °С and the driver
taking no control of the throttle
valve plate. When pressing the
accelerator pedal (until it stops)
in the engine start mode, the fuel
supply is locked for the drain
engine cylinders of excess fuel
after unsuccessful starts.
3. Switch on the starter. Hold
down the fully depressed clutch
pedal until the engine starting stops,
and the engine idle running. After
starting the engine, release the
ignition key – the starter will be
switched off.
Note. It is not recommended to switch
on the starter for more than 10 seconds.
5
Р.Э.-21900 англ. яз
65