Lada GRANTA, Руководство пользователя, Страница: 17 / 140

The windows automatic rolling
up/down with the help of DDM
key-buttons*.
When pressing the driver's win-
dow control button operating in the
rolling up/down mode for no more
than 1.5 seconds, then, after releas-
ing it, the window stops. If this appli-
cation time exceeds 1.5 seconds,
then the window will continue to
move automatically until it detects
the obstruction (see the relevant
Section), but for no longer than 10 se-
conds.
To control front passenger's door
right hand window with DDM key-
button, the automatic rolling down
mode is implemented, which works
similar to the driver's door window
rolling down mode.
The windows automatic rolling
up/down mode terminates when
rolling up against the stop or recog-
nizing an obstruction and/or when
pressing any window regulator con-
trol button on the DDM.
Rolling up/down windows with the
button in the passenger's door is
similar to the DDM buttons operation
with the following restrictions:
– only that door window is con-
trolled where the key-button is lo-
cated;
– it is impossible to control with
the button in the passenger's door as
long as you control the same or the
other window of the same side board
with DDM;
– it is impossible to control with
the rear passenger's doors buttons if
the inhibit mode on their operation is
enabled (see below).
In order to disconnect the power
window control from the switches,
located in the rear doors
(in the
design variant) , you should press
the button 9 on the DDM, thereupon,
the letter symbol will highlight
orange. To resume the power win-
dow control with switches located in
the rear doors, you should press but-
ton 9 on the DDM again. At that, the
orange highlight of the button letter
symbol will go down. The rear door
key-button operation inhibit mode is
maintained after the ignition switch-
ing off/on and the power supply sys-
tem connection/disconnection.
It is possible to control simultane-
ously two power windows, located on
different sides of the vehicle.
Obstruction recognition
The system operates the obstruc-
tion recognition mechanism when
rolling the window. In case of an
obstruction detection the window
stops until next controlling action
arrival.
In case the controlling actions on
one and the same power window in
the same direction follow more often
than one in every 5 seconds, the
obstruction recognition mechanism
becomes less sensitive, pending to
its overall switch-off. The obstruction
recognition mechanism enabling
occurs in 5 seconds after the last
controlling action.
Warning
During windows closing with
power windows fingers and other
body parts pinching is possible
15
* The automatic mode of the window rolling up/down is initially implemented in the factory delivery of the
DDM. The window regulator automatic control mode disabling is possible with the help of the diagnostic
tester at the certified SSNEs.