Laars OMNITHERM ONH1250, Инструкции по сборке, установке и эксплуатации

Страница: 63 / 136

Page 63
C O N F I G U R AT I O N
8.D.1.a.1 PID Low
Active below Setpoint.
Note that in most cases, PID parameters will not need to be changed. The PID Parameters Screen allows adjustment to
the following parameters:
• Proportional Gain
– This value is the corrective action that is proportional to the error (set point – control
temperature).
• Integral Time
– This value is applied to the sum of the error over a period of time.
• Derivative Time – This value is applied to the rate of change of the error.
8.D.1.a.2 PID High
Active from Setpoint
to Off Hysteresis of demand.
8.D.1.b
CH2- (Central Heat, Two)
Additional heat demand CH2 is available and is set up in the same manner as CH1.
The
O
MNI
T
HERM