La Germania AMS95C81ANE/20, Инструкция по установке, обслуживанию и эксплуатации

Страница: 5 / 44

5
4) With a slotted screwdriver turn the choking screw (see figure 11) and, while observing the flame at the same time through the
cooker porthole, evaluate the consistency of the flame so it remains on when switching quickly from the MINIMUM to the
MAXIMUM position.
WARNING: The above-mentioned adjustment should be made only with natural gas burners, while for those operating
with liquid gas the screw must be locked at the end in a clockwise direction.
WARNING: For the model with single control for grill and oven, the grill burner always operates at maximum and
therefore no minimum adjustment is required.
APPLIANCE ELECTRIC CONNECTION:
The electric connection must comply with the current legal standards and regulations.
Before making the connection, check that:
- The system electrical rating and the current outlets are adequate for the maximum power output of the appliance (see the label
applied to the bottom of the casing).
- The outlet or the system is equipped with an efficient ground connection in accordance with the current legal standards and
regulations. The company will not be responsible for the non-compliance with these instructions.
When the connection to the power supply network is made using an outlet:
- If the power cord is supplied without a plug, apply a standard plug that is suitable for the load indicated on the label. Connect
the wires according to the diagram shown in Fig.12 and check that:
letter L (phase) = brown wire;
letter N (neutral) = blue wire;
ground symbol = green-yellow wire;
- The power cord must be positioned so that an overtemperature of 75 K will not be reached at any point.
- Do not use reductions, adapters or splitters since they might cause false contacts and lead to dangerous overheating.
When the connection is made directly to the electric network:
- Insert an omnipolar circuit-breaker between the appliance and the network which is sized for the appliance load with a
minimum opening between the contacts of 3 mm.
- Remember that the ground wire must not be interrupted by the circuit-breaker.
- As an alternative, the electric connection can also be protected by a high-sensitivity residual current circuit-breaker.
- It is highly recommended to attach the special green-yellow ground wire to an efficient ground system.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service
agent.
APPLIANCE MAINTENANCE
ATTENTION: IMPORTANT WARNINGS
The appliance is not to be used by persons (includuing children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction
Children being supervised not to play with the appliance.
Warning: Ensure that the appliance is switched off before replacing the lam to avoid the possibility of electric chock
For cookers resting on a base
ATTENTION: If the cooker rests on a base, take the measures necessary to prevent the cooker from sliding along the support
base.
For cookers with glass covers
ATTENTION: Before opening the appliance’s glass cover, carefully remove all liquid residues from the top of it.
ATTENTION: Before closing the appliance’s glass cover, make sure that the work surface has cooled.
For cookers with electric ovens
The unit becomes hot during use. Do not touch the heating elements inside the oven.
For cookers with electric ovens
ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance.
For the food warmer compartment (or drop leaf in our case)
ATTENTION: The internal parts of the food warmer can become hot during use.
For glass doors
Do not
use abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s glass since this could
scratch the surface and the glass could break.
Do not use steam cleaners to clean the appliance.
NOTE:
various parts of the cooker heat up reaching temperatures which seem very high but which are actually fully within
safety limits. According to these limits:
1) With the oven on at 200°C for 1 hour, front accessible parts which cannot be grasped, can reach the following temperatures:
-
Control panel: Tmax = Room Tempe60°C
- Glass of the oven door: Tmax = Room temp60°C
-
Metal part of the oven door: Tmax = Room temp45°C
2) With the oven on at 230°C for 1 hour, the parts which can be grasped, can reach the following temperatures:
-
Plastic knobs: Tmax = Room temp60°C
-
Metal oven door handle: Tmax = Room temp35°C
where the room temperature is the temperature in °C of the place where the appliance is installed.