INSTALLATION GUIDE FOR
“C
HÂTEAU
” RANGE
- G4
08NOTINSTALG4/EN - 3
82
Figure 12: Injector for gas oven
Figure 13: Injector for lava rock grill
4.2
THE GAS OVEN AND THE LAVA ROCK GRILL
The gas oven or grill injectors are always replaced in the following sequence:
1.
Tighten the adjusting cone (2) to move it inside the mixing tube to clear enough space to loosen
the injector whilst keeping the ring clear.
2.
Unscrew the injector (1) using a no. 7 open-end spanner for the stone grill or no. 17 for the oven.
3.
Install the injector (1) corresponding to the new type of gas and tighten it.
4.
Adjust the air inlet (A) (see table below for adjusting the primary air) by screwing or unscrewing
the adjusting cone (2). Light the burner. The flame must be slightly blue, without separation.
Flame separation indicates that there is too much air.
5.
Then block the adjusting cone (2) with the blocking washer (3).
Access is gained to the oven injector either from the rear of the cooker or from the front by removing the
drawer. It is easier to change the injector by accessing it from the rear.
Rear of the cooker
Front of the cooker
Once you have changed the injectors, it is a good idea to adjust the low settings for the hob burners (see
Section 5).
1
1
1
2
2
3
3
Injector
Injector
