KZ Escape 2020, Руководство пользователя

Страница: 41 / 72

41
is completed, be sure to turn water off at the faucet.
Remember capacities of your water heater and gray water holding tank.
Long showers in a recreational vehicle are NOT suggested due to the
amount of water that is available. To conserve water, wet down, and turn
water off at shower head while you soap up, then rinse.
Sanitizing and Filling the Potable Water System
For your safety, you should sanitize your potable water system when your
recreational vehicle is new or when it has been sitting unused for a period
of time and it may have become contaminated.
Prepare a chlorine solution using 1/4 cup of bleach (5% sodium
hypochlorite solution) to one gallon of water. Prepare one gallon of this
solution for each 15 gallon capacity of the tank. As designed and
constructed, this method will sanitize the plumbing system.
For Gravity Fill Storage Tanks:
1. Close all the drains: tank, low-point drains, and have by-pass
closed to water heater.
2. Open lid on gravity fill and pour above contents into tank. A
funnel may assist your efforts or be required.
3. You may wish to add additional water for circulation.
4. Open all faucets to allow air to escape.
5. Turn on water pump to deliver water solution through coach
water lines.
6. Close faucets when air ceases to bubble out.
7. Allow solution to remain in tank and system for 3 hours.
8. Drain solution and flush as desired with fresh water.
Drainage (Fresh water)
All permanent fresh water tanks can be drained. Two types of drains are
used, (1) a push/pull or, (2) a turn valve with open/close position. Valve
is normally close to tank.
To drain the supply lines and the entire system, you need to follow the
steps listed below. Locate the valve placed at the floor level or close to
the floor, found under the dinette, storage cabinet, and sofa. These
valves will be at the “lowest” point of the water lines.
To drain system:
1. Open all faucets including optional exterior shower.
2. Open the fresh water tank drain.
3. Open the water heater drain.
4. Open all (two to four) low-point drains.
5. Open the toilet valve, hold or block if needed.
6. To empty the pump, start and allow to run up to 20 seconds.