KZ Escape 2020, Руководство пользователя

Страница: 33 / 72

33
Slideouts
Slideouts come in many sizes and different systems. In this model you
have what is
called “above floor slideout”. Meaning, all components are
located inside and above the floor, under the sofa or under the dinette. A
single mechanism is attached to a slideout and is accessible inside on
the floor.
Operating Instructions
NOTE:
1. Before operating the slideout room, level trailer front to rear and
side to side.
2. Extend ALL stabilizer jacks to make contact with ground and/or
solid blocks. Placing stabilizer jacks onto a hard surface allows
the coach to remain square and assures a good weather tight
seal between the room and trailer sidewall.
All power slides operate on 12-Volt DC power provided by converter thru
a 12-Volt distribution load center, with a 30 amp breaker for protection,
supplies power and safety for operation. For best performance, have 120-
Volt power attached. Tow vehicle power can be used, if required.
Switch is normally located under, in, or beside an overhead cabinet,
generally in kitchen area. Switch is spring loaded, so you will need to
hold it while moving slideout. Movement time is about 20 seconds, in or
out. In either direction of movement, there are gaskets that seal room
and coach from water and insects.
To open
—Hold switch until fully open ready to occupy.
To close
—Hold switch until fully closed.
No blocking is required or suggested to be used under slideout during
use. As it will distort water seals around slide out.
Manual Override
Should 12-Volt power fail and there is no 120 AC power available, follow
the listed directions. Access to the mechanism is under the floor of
slideout, sofa or dinette, and is from the inside. A 5/8 inch socket is
required plus ratchet and extension. Place socket on provided nut
supplied by the manufacturer of system. Turn in the direction needed to
move slideout.
There may be minor resistance but should move fairly easily.
DO NOT place pressure or force when open or closed
between gaskets and wall. It can cause bending of extrusion
when in or out.