KYMCO DINK 200, Руководство пользователя, Страница: 195 / 225

16
. BATTERY/CHARGING SYSTEM
16-4
DINK 200
BATTERY
Remove the seat and met-in box. (

2-3)
Remove the battery cover screw and the
battery cover.
Remove the battery.
First disconnect the battery negative (-) cable
and then the positive (+) cable.
The installation sequence is the reverse of
removal.
BATTERY VOLTAGE INSPECTION (OPEN
CIRCUIT VOLTAGE)
Disconnect the battery cables.
Measure the voltage between the battery
terminals.
Fully charged : 13.2V
Undercharged : 12.3V max.
CHARGING
Connect the charger positive (+) cable to the
battery positive (+) terminal.
Connect the charger negative (-) cable to the
battery negative (-) terminal.
Charging current : Standard : 0.9A
Quick : 4A
Charging time : Standard : 5
_
10 hours
Quick : 30 minutes
After charging: Open circuit voltage: 12.8V min.
Battery Cover Screw
When disconnecting the battery positive
(+) cable, do not touch the frame with
tool; otherwise it will cause short circuit
and sparks to fire the fuel.
•
Keep flames and sparks away
from a charging battery.
•
Turn power ON/OFF at the
charger, not at the battery terminals to
prevent sparks near the battery.
•
Charge the battery according to
the current specified on the battery.
•
During quick charging, the battery
temperature should not exceed 45
℃
.
•
Quick charging should only be done in
an emergency.
•
Measure the voltage 30 minutes after
the battery is charged.
＊
Battery charging inspection must be
performed with a voltmeter.
＊
First connect the positive (+) cable and then
negative (-) cable to avoid short circuit.