17
16
Installation Instructions
Ⅰ
Installation
Installation of separation cool and hot water type
Non-hole Valve
Hot Water Releasing Hole
Cold Water Releasing Hole
‘O’ Shape Packing
Water Entrance Control Valve
Hole Valve
‘O’ Shape Packing
‘O’ Shape Packing
‘O’ Shape Packing
All hookup part of pipe arrangement has to be covered by teflon tape for avoiding the leakage and you
control the bounding number of tape for keeping the level of a horizontality and a perpendicularity.
When you decompose and reassemble the product, if you give the over force, it will be possible to leak after
assembling the product because of a pipe arrangement distortion of raw water, a break out of rubber packing
and a breakage.
❶
After locking all raw water of installation area or type switch valve fixed on the
wall for cold and hot water connected with a water service pipe behind a tap as shown
in the figure by using a type screwdriver, check to cut off water completely by
opening a tap.
❷
Separate from the pipe for cold and hot water connected with a tap. (See the top figure)
※
Warning-When you decompose the product, if a rubber packing attached on the
nipple for preventing the leakage is worn out, you will change that.
unless it will cause a leakage of product.
❸
You wrap a teflon tape for preventing the leakage several times on nipples without
a hole and with a hole and link them.
Water Entrance Control
Valve Elbow
Product Water Entrance Hole
※
But standard of a nipple with a hole differs according to the area and a manufacturer
and if the size is not correct, you will order it separately.- We accept a request in the A/S
center.)
※
Warning-You wrap the tape for preventing the leakage 4~5 times not to harm on the
connection between nipple and piping and after complete connection, you have to adjust
the direction of a valve not to make a problem on the connection with the product.
❹
You link the switch valve with the nipple with a hole connected in 3) as shown
in the figure.
※
Warning-You wrap the tape for preventing the leakage proper times not to harm on the
connection between nipple and piping and after complete connection, you have to adjust
the direction of a valve not to make a problem on the connection with the product.
(As shown in the figure, after stopping down the nipple, the switch valve will be horizontal
so you control the amount of leakage tape as the same amount.)
❺
Insert the hose stop down nut at the hose and push the hose in the switch valve at the end.
After that connect the hose stop down nut with switch valve and stop down with proper
strength.
※
Warning-If you stop down the nut too strong, the water will be possible to leak because
the hose in the hose stop down nut can be torn. Or if you stop down the nut too loose,
the water will leak because the hose is missed from the switch valve.
So you connect the hose safely by giving the proper strength carefully.
❻
How to connect with the product after connecting the hose with a tap pipe
After selecting the proper place for the product, cut the length of hose with some extra to
the product. As shown in the figure, remove a rubber plug in the raw water inlet and put
the hose in the raw water inlet. At this time, you put the hose at the end not to miss from
the product.
Power cord
Receptacle
ON/OFF power switch
Water drain
outlet
Water supply inlet
