25
24
1
.
Lay the product on its back on your countertop where it will be placed when you are operating it so that
the bottom of the unit is accessible.
2
.
Attach the power cord to the bottom of the product and turn the master power switch to the ON position.
See “Power Cord” on page 24. DO NOT plug the unit in at this time.
3
.
Press the power cord into the middle guide slot on the side from which the power cord will exit the unit
towards the electrical outlet into which the product will be plugged.
4
.
Using a pair of scissors carefully cut the plastic clasps that are attached to the 1/4 inch tubing provided
with your product.
5
.
Cut this tubing into two equal halves.
6
.
Remove the gray plugs in the IN and OUT quick connect connector by locating the outer ring around the
plug, then pushing this ring toward the body of the product, while gently pulling the plug out.
7
.
Insert one end of one of the tubing halves into the IN quick connect connector on the bottom of the
product. See “Bottom View (A)” on page 24. To insert the tubing, hold the connector with one hand and
insert the tubing into the connector with the other hand until it is pressed all the way into the connector
(IMPORTANT).
8
.
Insert one end of the other tubing half into the OUT quick connect connector on the bottom of the Genesis.
See “Bottom View (B)” on page 24. Make sure the tubing is pressed all the way into the connector
(IMPORTANT).
Note: To remove tubing from a quick connect connector, push the ring on the connector in (towards the body
of the product) and gently pull out the tubing, just like removing the plugs.
9
.
Turn the connectors (and tubing) in the direction needed to exit the tubing toward the sink.
10
.
Press the tubing into the guides at the edge of the product. See “ Bottom View (E) on page 24.
11
.
Attach the tubing connected to the OUT connector to the acid line sink attachment. “See Acid Water
Drain Tubing” on page 24. This will insure that the IN tubing and the OUT tubing can be correctly identified
later without having to recheck the bottom of the unit.
12
.
Set the product in an upright position and place it where you intend to use it.
13
.
Both the “IN” tubing and the “OUT” tubing should be exiting the product toward sink.
If they are not, lay the unit on its back and switch the direction of the connectors and tubing accordingly.
14
.
Locate the stainless steel faucet head diverter valve and the stainless steel male/male adapter and set
these next to your sink.
A
:
Water Drain Tubing
B
:
Suction Cup
Delivery Hose Connection
Ionized Water Delivery Hose
A
:
1/4
″
Water Supply Tubing
B
:
Faucet Diverter Valve
C
:
Water Conter Knob
A
:
Water Supply Inlet Valve (Labeled in)
B
:
Drain Water Outlet Valve (Markee out)
C
:
Master power ON/OFF switch
D
:
Power cord receptacle
E
:
Guides for Tubing and Power Cord
Power Cord
Touch Sensor Panel
Installation Components Continued
Countertop Installation Instructions
