•
To replace its battery, remove the small Phillips head screw located on the lower
back and replace with a type 27A, 12volt alkaline cell.
8.
PROGRAMMING THE DISPLAY
The speed codes and their meanings
Read over the following programming codes listed in the Speed Code Table below to
become familiar with the two-letter groups (modes) you want to set in the sign using
the push button. Concentrate on the “Normal Mode” (NM) and “Violator Alerts”
(VA) modes only, for now.
Notice that they are grouped so that for
example, when
“VA” is selected, you can set the “Minimum Speed”, Flash (speed), Blank (speed),
etc. As the last numbers are entered, the display is ready and goes blank.
SPEED CODE TABLE
Two-letter Mode
Meaning
Description
NM
=>
“Normal Mode”
Sign shows all speeds normally
with no speed filtering
VA
=>
“Violator Alert”
“
Violator Alert”
MENU
MS => “Minimum. Speed”
Min. speed for sign to display
SL
=>
“Slow”
Speed at which red “SLOW”
shows (Optional Feature)
RB
=>
“Red & Blue”
Flashing “Red & Blue” speed
(Optional Feature)
FL => “Flash”
Speed at which to flash readout
BL => “Blank”
Speed at which to blank screen
**
ND
=>
“No Display”
Unit collects radar data with no display
**
OPTIONAL ONLY
for units with the
optional data collection software feature.
Feature must be enabled - See Advanced
Features Mode Section.
SETTING THE SIGN IN “NORMAL MODE”
The simplest mode to put the sign into is the “NM” (Normal Mode).
Instructions:
1.
Turn the power on with the key. After the brightness number changes, start
pushing the button and stop on the two letter code “NM”.
2.
As the display goes dark, it is now running in “Normal Mode”. In other
words, the sign will display the speed of oncoming vehicles from 5 mph
(down to 1 mph is also available, see Advance Features Section) to 99 MPH
