Availability was on and will now be turned off. We recommend the Set Time Availability
be “Off” for most applications.
“Optional” Slow and Red Blue Violator Features
These features are built in to your radar display but may not be configured to operate
because they are either not appropriate for the application or were not purchased.
These optional Violator Alerts may be viewed by running the demo mode in the “Advanced
Features” section of this manual.
Please contact Kustom Signals should you have any questions or need further assistance.
11.
SETTING THE CLOCK AND TIMED EVENTS
Note
:
Unless the sign is to be powered on and off automatically at certain times, it is
not necessary to set the clock
The internal timer is a 24 clock used to turn off the display’s system to extend
battery life or to prevent disturbing residents at late or early hours
.
This feature will
not take into account weekends, holiday or daylight savings time.
The Set Time
function must first be “turned on” in order to set the On/Off times. See Section 10 –
Advanced Features, code 9989 to activate this function. Once the feature is activated,
you will see the following codes added to the startup display setting:
TIMER CODE CHART
ST
=>
“Set Time”
Time Set Menu
EN
=>
“Enable”
Turn on the timer feature
DS
=>
“Disable”
Turn off the timer feature
ON
OH
=>
“On Hour”
Hour at which sign is to turn on
OM
=>
“On Minute”
Minute at which sign is to turn
OFF
FH
=>
“Off Hour”
Hour at which sign is to turn off
FM
=>
“Off Minute”
Minute at which sign is to turn
TIME
HR
=>
“Hour”
Set current time hour (24 hour)
MN
=>
“Minutes”
Set current time minute
SETTING THE EVENT TIMER
Note:
If you become lost while setting any of the numbers, the settings operate the same as
the display set. In other words, if any numbers are missed the first time around, they will
repeat again by holding in the pushbutton. Also, the power key can be cycled on and off to
start over from the beginning or the key chain remote option allows you to advance or
reverse all numbers using both of its buttons.
As an example, let’s set the sign to operate only during normal to high traffic hours
(for conserving the battery) to run daily from 5:30 AM to 11:45 PM. The current
time is 8:17 AM. These would be the programming steps:
