Violator Alert 4: FL - Flashing Speed
The display will now show “FL”. When drivers go over this setting, they will see
their over-the-limit speed flash. The operator has 5 seconds to start pushing the
button in order to change the speed setting. Press the button until the desired speed
setting is reached. Once reached, stop and wait for the next screen to appear after
approximately 5 seconds.
“Flashing Speed”
Violator Alert 5: BL - Blanking Speed
The display will show “BL” which is the speed limit that the display will no longer
show the oncoming vehicles speed. This setting will prevent drivers from increasing
their speed over this speed limit to see how fast they can go. Press the button until
the desired speed setting is reached. Wait approximately 5 seconds and the sign will
go dark. The display is now in service and operating in “Violator Alerts” mode.
“Blanking Speed”
**
Optional SLOW and Flashing Red & Blue Violator Alerts can be purchased and
activated at any time. Call Customer Service 866-982-2107 for pricing and information.
Notes:
•
After this last “BL” screen, all of the violator alert settings have been saved even
after the sign is switched off. When the sign is turned on again, it will run thru all
of the modes and their speed settings for the operator to review.
•
If changes are needed, press the sign mounted button for 5 seconds which will
start the mode settings to display again. If using the key chain remote, hold the
left button in for 1 second for the same effect.
•
If desired, the sign can be pre-set at your base facility for transportation and set-
up at a different location.
•
The violator alerts can be set in any order, but not at the same speed. If
attempted, this setting will skip to the next available number. To get the best
effect from the alerts, set the speeds at least 3-4 MPH difference. If you wish to
not use one of the violator alert settings, set the speed high, i.e. 97 MPH.
•
Holding the button will scroll through the numbers faster for quicker setup. If the
desired setting is passed, the numbers will start over after 99.
