background image

Step

1

Turn on radio

2

Decide what channel to be used 

3

If channel is already used it will need to be deleted (i.e. cleared) first

4

Press menu button

5

If channel is to be deleted perform following 4 steps else go to step 6

5a

Press menu button (should show "CH-??" where ?? Is the channel number to be deleted.  This shows the 

channel is programmed"

5b

Select up/down arrow to select channel to be deleted

5c

Press menu button (should now show  "??" where ?? Is the channel number which was deleted.  The lack 

of the "CH" is shows the channel is NOT programmed"

5d

Press exit button

6

Select "frequency" mode using the VFO/MR button

7

Enter receive frequency

8

Press menu button

9

Select menu option 26 to check frequency offset if this frequency is using a repeater

10

If using a repeater and offset in option shows 0, perform following 3 step else go to step 11 

10a

Press menu button

10b

Enter frequency offset usually ".600" for VHF and  "5" for UHF 

10c

Press menu button

11

Select menu option 25

12

If using a repeater and offset in option shows off, perform following 3 step else go to step 13

12a

Press menu button

12b

Using arrow buttons select "-" or "+" offset as required for the specific repeater

12c

Press menu button

13

Select menu option 13

14

If using a repeater which uses a transmit CTCSS tone (tone allowing access to the repeater) and tone is not the 

same as the one required by the repeater (could be "off" or some incorrect value), perform following 3 steps else

 go to step 15 

14a

Press menu button

14b

Using arrow buttons to select correct CTCSS value (i.e. 88.5, 100, etc)

14c

Press menu button

15

Select menu option 11

16

If using a repeater which uses a receive CTCSS tone (tone sent by repeater to open squelch on user's radio) and

 tone is not the same as the one required (could be "off" or some incorrect value), perform following 3 steps else

 go to step 17.  NOTE:  This can be set to "off" and radio will receive using the received repeater signal

 to "break" the squelch.

16a

Press menu button

16b

Using arrow buttons to select correct CTCSS value (i.e. 88.5, 100, etc)

16c

Press menu button

17

Select menu option 2

18

If transmit power is not at level desired, perform the following 3 steps else go to step 19

18a

Press menu button

18b

Using arrow buttons to select correct CTCSS value (i.e. 88.5, 100, etc)

18c

Press menu button

19

Select menu option 27

20

Press menu button

21

Select up/down arrow to select channel where the information is to be stored.  (should show "??" where ?? Is the 

channel number where the information is to be stored.  If CH-?? is shown it means the channel is already

 programmed

22

Press menu button (should now show  "CH-??" where ?? Is the channel number which was stored.  The lack 

Action

Steps to program a repeater into a channel for a Boafeng radio (UV-5)

Отзывы: