5-36
Descriptions of Parameters
System Parameters
MIDIScope?
Not a parameter but a prompt to run MIDIScope, a MIDI-analysis application. Monitors any
event from the PC2Õs keyboard or controllers, as well as MIDI information (including SysEx
messages received at the MIDI In port. Press any non-controller button to exit.
The MIDI Recv Menu
The MIDI Recv menu is designed to make it easy to conÞgure your PC2 as a MIDI slave, with a
set of parameters for deÞning how it responds to incoming MIDI information. Each channel has
an independently-programmable set of the parameters described below. The settings for these
parameters affect the PC2Õs performance modes, as well as how the PC2 transmits MIDI
information.
You can easily select MIDI channels by holding the
MIDI Recv
button and pressing
Sound/Setup select buttons
1
Ð
16
to select channels 1Ð16.
Channel Activation (No parameter name shown)
Activates/deactivates current channel.
Program ID and Name (No parameter name shown)
SpeciÞes a program for the current channel. Transmits the program change both to the PC2 and
to the MIDI Out port.
Volume (Vol)
Sets the volume level for the current channel.
Pan
SpeciÞes the pan setting for the current channel. A value of 0 is full left; 64 is center; 127 is full
right.
A-to-B Wet/Dry Mix (Global A>B)
For the current program on the current channel, speciÞes how much of the processed signal
coming from FX-A goes to FX-B and gets FX-BÕs effect applied to it. Also transmits values to the
MIDI Out port.
FX-A Wet/Dry Mix (A)
For the current program on the current channel, speciÞes how much of FX-AÕs effect gets
applied to the dry signal coming from the Pc2Õs sound engine. Also transmits values to the MIDI
Out port.
FX-B Wet/Dry Mix (B)
For the current program on the current channel, speciÞes how much of FX-BÕs effect gets applied
to the dry signal coming from the sound engine. Also transmits values to the MIDI Out port.