Chapter 2
Startup
Setup
When setting up the PC2 for use it must be placed on a sturdy, level surface where both ends of
the unit are supported. A conventional keyboard stand may be used if it is strong enough to
support the unitÕs weight (about 35 pounds for a PC2, 50 for a PC2X). If you are going to be
using the unit on a table now or in the future, apply the four stick-on rubber feet to the bottom.
Figure 2-1 shows the recommended locations marked with pairs of small guide holes. Remove
the backing paper from each rubber foot and attach just forward of each set of guide holes. It is
possible that these locations could interfere with some keyboard standÕs supports, so check how
the PC2 Þts on your stand before applying the rubber feet.
Figure 2-1
Attaching rubber feet
Installing the Music Rack
YouÕll need a Phillips screwdriver to install the optional music rack.
1. Remove the four screws on the rear panel of the PC2, as shown in Figure 2-2.
2. Use the screws to attach the music rack bracket, making sure that the rounded edge of the
bracket is at the top.
3. Slide the music rack in from the top (as shown in the Þgure).
Attach feet here
