Descriptions of Parameters
Setup Editor Parameters
5-7
This parameter selects the bank for the current zone. It also determines which bank-select value
the zone sends via MIDI when you select the setup (the zone wonÕt send a bank-select message
to the MIDI Out port if it has a value of
Local
for the Dest parameter in the MIDI Xmit menu).
Program ID and Name (No parameter name shown)
When you select this parameter, the top line of the display shows the current zone of the setup
youÕre editing, as well as the bank ID and program ID of the program assigned to the zone. The
bottom line shows the ID and name of the program assigned to the current zone.
This parameter selects the program for the current zone. It also determines which program-
change value the zone sends via MIDI when you select the setup (the zone wonÕt send a
program-change message to the MIDI Out port if it has a value of
Local
for the Dest parameter
in the MIDI Xmit menu).
Note
: When you press the
Program
button, the Þrst parameter you see is the Program ID and Name
parameter. To get to the Bank parameter, press
<
once.
Entry Transmit
Determines whether the current zone sends a program-change command when you select the
setup. If its value is
On
, the zone transmits the program ID of the program assigned to the zone
(as shown in the top line of the display when youÕre viewing this parameter). This is the setting
for each zone in the default setup. The program-change message may include a bank-select
message, depending on the value of the Bank Mode parameter.
If the value of Entry Transmit
Off
, the zone doesnÕt send a program change when you select the
setup.
The function of this parameter depends on the setting of the Dest parameter. If the current
zoneÕs setting for Dest is
Local
, the zone doesnÕt send a program-change command to the MIDI
Out port when you select the setup, even if Entry Transmit is set to
On
.
Bank Mode
Determines what type of bank-select message, if any, the zone sends when you select the setup.
A value of
None
prevents the zone from sending a bank-select message. If the value is
0
, the
zone sends a MIDI 0 message, with a value equal to the ID of the current bank. If the value is
32
,
the zone sends a MIDI 32 message with a value equal to the ID of the current bank. Values of
0
and
32
enable you to select banks numbered from 0Ð127.
If the value of Bank Mode is
0/32
, the zone sends both MIDI 0 and MIDI 32, combined as a single
value. This enables you to select banks numbered from 0-16,383. Since many of todayÕs MIDI
instruments respond to this form of bank-select message (as recommended by the MIDI
speciÞcation),
0/32
is the value of Bank Mode in each zone of the default setup.
There are two other values for Bank Mode:
K2000
and
K1000
. These enable you to send bank-
select and program-change commands to older Kurzweil instruments, which use a different
system for numbering programs. The manuals for these instruments explain the numbering
system thoroughly.
The function of this parameter depends on the setting of the Dest parameter in the MIDI Xmit
menu. If the current zoneÕs setting for Dest is
Local
, the zone doesnÕt send a bank-select
command to the MIDI Out port when you select the setup, regardless of the setting for Bank
Mode.
