Kurabo QuickGene-810, Руководство по эксплуатации

Страница: 45 / 78

QuickGene-810 Operation Manual
Rev. 1.7
21
3 Operation
1
3
2
5
4
6
7
(5) Put buffers (wash buffer and elution
buffer) into conical tubes.
Large conical tube: wash buffer
Small conical tube: elution buffer
(6) Set the conical tubes, which were
prepared in (4), into the Buffer Stand,
and put Tube Caps on the conical tubes.
(7) Close the front cover.
(8) Press the [DISCHARGE] button on the
operation panel.
3.3 Preparation of Lysate (Samples)
Prepare lysate (samples).
Make lysate(samples) using the specified kit for each sample.
For details, refer to the kit's handbook.
3.4 Extraction Operations
This section explains each operation before the start of a program and after the completion of a program.
■
Operations before the start
Important:
Buffers can be used for a day in the
conical tube inside the QuickGene-810.
Note: Do not touch the inner tube of Tube
Cap. In the case of contamination,
please refer to "6.4 When the Buffer
is Contaminated"(
→
page 46).
Large conical tube Small conical tube
Elution buffer Wash buffer
Tube Cap (Blue)
Tube Cap (Purple)
Small conical tube
Large conical tube
Important: Perform the extraction operation according to the following procedures.