Kurabo QuickGene-810, Руководство по эксплуатации

Страница: 36 / 78

1
2
6
3
4
5
7
1 Installation
12 QuickGene-810 Operation Manual
Rev. 1.7
(6) Connect the tube on the device side to
the Pump Tube as the figure.
Connect the upper tube to the Wash Buffer Pump,
and connect the lower tube to the Elution Buffer
Pump, by turning as shown in the figure.
■
Setup the Buffer Stand
The following explains how to install the Buffer Stand.
(1) Attach the Buffer Stand to the
QuickGene-810.
Insert the tabs of the Buffer Stand in the slits on the
QuickGene-810.
(2) Set empty conical tubes into the Buffer
Stand.
Set two conical tubes (for elution buffer and wash
buffer).
When using standard conical tubes, attach the
adapter to the Buffer Stand.
(3) Set the Discharge Tray to the Buffer
Stand.
To Wash Buffer Pump
To Elution Buffer Pump
Note: When the carrier is on the left and it
is difficult to attach the Buffer Stand,
close the front cover and press the
[CR MOVE] button. Then the carrier
moves to the right end.
Tab
Slit
Slit
Buffer Stand
Buffer Stand
Adapter
Conical Tube
Discharge Tray
When setting standard
conical tubes