- 12 -
ASSEMBLY INSTRUCTIONS
1) Frame assembly (photos 1 and 1 A)
Fix box type frame (P) onto crossbar (T) with 4 bolts
(D) (M 12 x 100 and self -locking nut M 12), 1 bolt (D')
(M 12 x 110 and self-locking nut M 12) and onto the
central gearbox (J) with 6 screws (K) (M 12 x 35).
Torque hardware to 12 daNm/72 ft.lbs.
NOTE
: Do not forget to insert support (L) between
box type frame (P) and self-locking nut (M
12) when installing bolt (D) (photo 1A).
Next attach hydraulic hoses (R & S) to T union (U)
and hydraulic cylinders (V) (photo 1 A).
Install bolt (Z) and tighten locknut (Y).
Connect wire rope (Q), which automatically locks and
unlocks pendulum arm, to plate (R) with rope grip (W)
as shown in photo 1. Adjust wire rope length so that it
is slightly tensioned when the outside rotors are lifted
into transport position. Cut off surplus rope.
2) Fitting the 3-point frame (fig 2)
Attach the 3-point frame (C) to the box type frame
(P) by means of the vertical pivot pin (A) and secure
in place with roll pins (E) (5 x 50 mm) and (E) (8
x 50 mm) as shown in figure 2. Then attach the
pendulum arm (B) to the 3-point frame (C) by means
of the horizontal pivot pin (F).Secure the horizontal
pin (F) with roll pins (G) (8 x 50 mm). The roller (H
) must locate in housing (I).
3) Fitting the stand (photo 3)
Slide parking stand (M) in housing (N) and fit roll pin
(P) (dia. 7 x 45). Lock the parking stand in the lowered
position with R-clip (O) and install PVC cord (Q) as
shown in photo 3.
1
