KUHN GA 8001 H, Руководство по сборке и эксплуатации

Страница: 28 / 52

- 26 -
13. Mounting of the safety guards (fig. 10)
- Then attach the coupling hose (18) and the traction spring (19) to the lower end of the adjustment screw (22)
using 1 bush (20) and 1 roll pin (21) (diameter 6 x 40).
- Mount the left rear crossbar (1) on the rear side of the swinging arm (2) using 4 self-locking screws (3) (M 12
x 55) and 4 spacers (23) (diameter 13 x 25 x 25).
- Mount the left side beam (4) on the swinging arm (2) and the rear crossbar (1) using 6 self-locking screws (3)
(M 12 x 55) and 6 spacers (23) (diameter 13 x 25 x 25). Torque : 8.5 daNm/ 60 ft.lbs.
- Mount the inner tube (5) of the left safety guard on the side beam (4) and the rear crossbar (1) with 4 hexagonal
screws (6) (M 10 x 50), 4 plain washers (7) (diameter 11 x 24 x 2) and 4 self-locking nuts (8) (M 10).
- Mount one end of the left foldable safety guard (9) on the side beam (4) with 2 hexagonal screws (6) (M 10 x
50), 2 plain washers (7) (diameter 11x24x2) and 2 self-locking nuts (8) (M10), and on the other side on the rear
crossbar (1) with 1 pin (10), 1 to 3 plain washers (11) (diameter 22.5x30x1) according to the clearance, 1 roll
pin (12) (diameter 8 x 40) and 1 self-locking screw (13) (M 10x16). Check that the self-lubricating bushes(14)
are installed in their housing.
- Mount the rear safety guard (15) on the rear crossbar (1) using 4 hexagonal screws (16) (M 10x55), 4 plain
washers (7) (diameter 11x24x2) and 4 self-locking nuts (8) (M 10).
- Install the crank handle (17) passing it through the holes of the side beam’s bracket (4).
- Then attach the coupling hose (18) to the crank handle (17) using 1 bush (20) and 1 roll pin (21) (diameter 6
x 40).
- Mount a grease zerk on the pin (10)
- Proceed in the same way to mount the right safety guard.
The necessary mounting hardware is packed in a parcel marked «protecteurs» 078 717 10.